Each blast is a distinct event. Monitoring data is more useful when it can be linked to the right blast and the correct position on the building. Before work begins, the monitoring provider and blasting contractor should agree how this information will be exchanged.

Agree recording and contacts before the first blast

Identify the affected buildings, planned blasting area and work period. Document instrument positions and settings. If a monitor moves, record the change so later comparisons do not assume an unchanged location.

Blasting may also produce air overpressure. Whether to measure this is a separate planning question. Vibration readings alone do not describe every aspect of an event. NS 8141-1 addresses measurement methods and guidance limits for effects on structures; the specific assessment must reflect project conditions.

Match the blast to the measurement

The report should contain clear times and references so an event can be found in the blasting log. If something feels unusually strong inside the house, record the time and what you observed. Retain photographs if you notice a change.

A recorded peak is one part of the assessment. Where damage is in question, it must be considered alongside the building’s earlier condition, monitor location and other investigations. A screenshot containing one number is a poor basis for a conclusion.

After the work, both the relevant reports and their associated logs should remain retrievable. Contact us about monitoring during blasting, including the location, timing and available project information.

What to check

  • Agree how blasts and measurement events will be identified.
  • Establish whether factors beyond vibration need measurement.
  • Keep reports with the relevant blast references.